Results 1 to 4 of 4

Thread: brush flipping up-down

  1. #1
    Join Date
    Jan 2016
    Posts
    25

    brush flipping up-down

    let's say I created a double color brush (using 'unlean brush', and loading it with 2nd color by driving it at a border of a blob of second color). Let's say red is at the top of the brush, and green at the bottom. Now I want to paint left to right, lift the brush up, next right to left, lift the brush, left to right , lift the brush, and so on. I expect the red to remain always at the top and green always at the bottom. But sometimes the colors get switched, ie red ends up at the bottom and green at the top. Not a natural behavior I would expect from paiting back and forth with a conventional brush. How can I stop swapping the colors? thanks
    p.s. Galaxy Note 10.1 2014, which doesnt support tilt of the stylus

  2. #2
    Join Date
    Nov 2013
    Posts
    1,993
    This is probably due to the direction of your stroke - without tilt, ArtRage will assume that you've rotated the brush so that your strokes are consistent.

  3. #3
    Join Date
    Jan 2016
    Posts
    25
    thanks. Im wondering if you could discuss it with the programmers? I suspect this was intentional to help painting arcs and circles. Maybe there is a way to disable such behavior?

  4. #4
    Join Date
    Nov 2013
    Posts
    1,993
    I'll pass it along, but the brush engine is quite complicated and this is built right into the simulation, so the answer is probably no.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •